+44 (0)1932 564391

Find your local representative

Setaflash Series 8 ActiveCool Flash Point Tester with Gas Ignitor

Part Number 82110-0

The Setaflash Series 8 'ActiveCool' is an automated closed cup flash point tester with two modes of operation; Flash or No Flash and Ramp.

The ramp mode increases the sample temperature at a rate of 2C/min and automatically dips the ignitor every 1C up to 100C (every 2C above 100C), until either a flash is detected or the end of test temperature is reached.

Temperature range (Air cooled)
10C to 130C (50 to 266F)

Temperature range (Water cooled)
-20C to 130C (-4 to 266F)

Flash point testing at low temperature
For tests with a starting temperature of 10C (50F) or lower, the Series 8 Active Cool must be connected to a chilled water supply that is maintained at 5C with a flow of at least 0.6l/min.
Stanhope-Seta Mini Low Temperature Bath/Circulator 99300-4 is an approved chiller for this application.

Bio fuel compatibleBio fuel compatible
Calibration and verification equipment availableCalibration and verification equipment available
Setaflash Flash point tester ASTM/IP


10C to 130C (-20C with external water supply)
Small sample size, 2 or 4ml
Flash/No Flash & Ramp modes
Gas ignitor
Automatic dipping and flash detection
ActiveCool electronic Peltier cooling
64 Test memory & RS232 interface
C or F temperature display


ASTM D3278, ASTM D3828, ASTM D7236, ASTM D8174, ASTM E502, BS EN ISO 3679, BS 2000-523, CLP Regulations EC No 1272/2008, EPA 1020 A & B, IP 523, IP 524, IP 534, ISO 3679, UN Class 3 Non-viscous Flammable Liquids


Petroleum - Fuels & Oils

Crude Oil



Energy & Power

Chemicals & Solvents

Cosmetics & Fragrances



Transportation, Storage & Packaging

Paint, Varnish & Waxes


Printing Inks

Waste & Environmental



Copyright Stanhope–Seta Limited 2014