+44 (0)1932 564391

Find your local representative

Setaflash Series 8 ActiveCool Flash Point Tester - Corrosion Resisting Cup

Part Number 82150-0

The Setaflash Series 8 ActiveCool is an automated closed cup flash point tester with a temperature range of 10 to 130C (50 to 266F). The temperature range can extend down to -20C (-4F) if you connect the flash point tester to suitable chilled water supply.

There are two modes of operation:
- Flash/No Flash
- Ramp

The ramp mode increases the sample temperature at a rate of 2C/min and automatically dips the ignitor every 1C up to 100C (every 2C above 100C), until either a flash is detected or the end of test temperature is reached.

Stanhope-Seta Mini Low Temperature Bath/Circulator 99300-4 is an approved chiller for lowering the temperature.

Bio fuel compatibleBio fuel compatible
Calibration and verification equipment availableCalibration and verification equipment available
Setaflash Flashpoint tester ASTM/IP


Small sample size, 2 or 4ml
Electric ignitor
Automatic dipping and flash detection
ActiveCool electronic Peltier cooling
64 Test memory & RS232 interface
C or F temperature display
Corrosion resisting insert


ASTM D3278, ASTM D3828, ASTM D7236, ASTM D8174, ASTM E502, BS EN ISO 3679, BS 2000-523, CLP Regulations EC No 1272/2008, EPA 1020 A & B, IP 523, IP 524, IP 534, UN Class 3 Non-viscous Flammable Liquids


Petroleum - Fuels & Oils

Crude Oil



Energy & Power

Chemicals & Solvents

Cosmetics & Fragrances



Transportation, Storage & Packaging

Paint, Varnish & Waxes


Printing Inks

Waste & Environmental



Copyright Stanhope–Seta Limited 2014