+44 (0)1932 564391

Find your local representative

Setaflash Series 8 Closed Cup Flash Point Tester - High Temperature

Part Number 82000-0

The Setaflash Series 8 is an automated closed cup flash point tester with a temperature range of ambient to 300C (ambient to 572F). The instrument uses an electric hot wire ignitor.

There are two modes of flash point operation:
- Flash
- No Flash and Ramp

The ramp mode increases the sample temperature at a rate of 2C/min, allowing determination of a flash point in accordance with ASTM D7236 and IP 534. The dipping sequence occurs automatically every 1C up to 100C (every 2C rise above 100C), until either a flash is detected or the end of test temperature is reached. The ignitor uses a new electrical hotwire (a gas flame option is available).

Bio fuel compatibleBio fuel compatible
Calibration and verification equipment availableCalibration and verification equipment available
Setaflash Flash point tester ASTM/IP


Ambient to 300C (Ambient to 572F)
Small sample size, 2 or 4ml
Flash/No Flash & Ramp modes
Electric ignitor
Automatic dipping and flash detection
64 Test memory & RS232 interface
C or F temperature display
Forced air cooling for rapid test cycling


ASTM D3278, ASTM D3828, ASTM D7236, ASTM D8174, ASTM E502, BS EN ISO 3679, BS 2000-523, IP 523, IP 524, IP 534


Petroleum - Fuels & Oils

Crude Oil



Energy & Power

Chemicals & Solvents

Cosmetics & Fragrances



Transportation, Storage & Packaging

Paint, Varnish & Waxes


Printing Inks

Waste & Environmental



Copyright Stanhope–Seta Limited 2014